Canadian Canoe Routes
http://www.myccr.com/phpBB3_PROD/

Advice on repairing a blind hole - Kevlar Canoe
http://www.myccr.com/phpBB3_PROD/viewtopic.php?f=49&t=48031
Page 1 of 1

Author:  twilson [ June 4th, 2020, 2:30 pm ]
Post subject:  Advice on repairing a blind hole - Kevlar Canoe

Hi there - I recently purchased a well used Bluewater 16'6" kevlar canoe. The original plan was to simply refinish the exterior with epoxy.

As things go I was removing some material to promote a better bond with the new epoxy and found a soft spot in some resin near the bow on the keel. I continued removing material and it became apparent that this was a botched repair.

I am now left with the hole in the photos below, l am looking for some advice on how to repair this hole. I cannot access the back through the interior of the canoe because of a built-in bulkhead at the bow.

I have come across a few blind hole repairs online but they don't exactly reflect the situation I have found myself in.

Please let me know if you have any advice on how to best fix this.

Tyler

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/